:	May 12, 2004

.

Disconnect the battery ground cable.

.

Remove the accessory drive belt.

.

Remove the splash shield.   Remove the 4 clips.

.

: Always plug any open connections to prevent contamination. Disconnect the low pressure line.   Remove the power steering line bolt.   Allow the fluid to drain into a container.   Remove and discard the O-ring seal.

.

Disconnect the high pressure line at the steering pump union.   Remove and discard the O-ring seal.

.

Release the power steering line support bracket.   Remove the bolt.

.

Remove the power steering pump front retaining bolts.   Remove the 2 bolts.

.

Remove the power steering pump rear retaining bolts.   Remove the 2 bolts.

.

Remove the power steering pump.

.

Position the power steering pump and install the front retaining bolts.   Tighten the bolts to 25 Nm (18 lb.ft).

.

Install the power steering pump rear retaining bolts.   Tighten the bolts to 25 Nm (18 lb.ft).

.

Connect the high pressure power steering line to the power steering pump.   Install a new O-ring seal.   Tighten the union to 25 Nm (18 lb.ft).

.

Connect the low pressure line to the power steering pump.   Clean the component mating faces.   Install a new O-ring seal.   Tighten the bolt to 25 Nm (18 lb.ft).

.

Install the power steering line support bracket.

.

Install the accessory drive belt.

.

Install the splash shield.

.

Connect the battery ground cable.

.

Fill and bleed the power steering system.